Cutting through a case..

[folex187]

:?: What do you guys use to cut through your cases?? I need to cut a good section out of the top and front so I'm considering just being careful and using a dremel.. What do you think?
-Alex

[Lem6687]

well thats what most everyone uses to cut throught there case, a dremel....go with that.

[n0strax]

for my windows on my aluminum lian-li case i used a dremel tool with some #426 cut-off wheels

[Tunnelvision456]

I need to do some precision cutting, and I'm thinking of getting one of those rottery drill saws. Not sure if that'll be best though.

[64thunderbolt]

Iv used a Jig-saw with very good results, alot fast then a dremel...

Charlie

[folex187]

I've got quite a bit of cutting to do to make my radiator fit now too. The metal I have to go through it kinda thick so I hope the old dremel cna make it through.. Wish me luck!
-Alex

[WVJammer]

The rotozip is good for metal, but on plastic you have to slow it waaaayyy
down. And be sure and get the right bits. they fly off faster than cheap cutting wheels on a dremel. :D

[grosser Vati]

try a jigsaw..use a blade with atleast 34 teeth per inch(34 tpi).
take your time!!!
10x faster & cheaper than a dremel

this is just my experience & opinion!!!

gV

[johnnyxxl]

maybe depending on the size of cuts etc a die grinder or I tungston cutting bit on a drill THere are also metal knibbler tools