Lumin PC

[imported_Yoshi]

Here is the writeup on TechTV's site (http://www.techtv.com/screensavers/modtips/story/0,24330,3547184,00.html)

[imported_Yoshi]

bare panel

[imported_Yoshi]

all three panels

[imported_Yoshi]

fragile bits on the panels

[imported_Yoshi]

raw plastic for framing the panels.

[imported_Yoshi]

A middle spacer piece,after being freshly laser cut.

[imported_Yoshi]

more cut panels.

[imported_Yoshi]

lasering the logo in the front panel.

[imported_Yoshi]

Using the panels to mark the location of the screw holes.

[imported_Yoshi]

I used regular masking tape to hold the panels in position while the holes were being marked.

[imported_Yoshi]

All the bits cut and ready to be assembled.

[imported_Yoshi]

Front panel loose mounted to check fit.

[imported_Yoshi]

mounts for the lumin panel, power supplies.

[imported_Yoshi]

One of the lumin power supplies mounted.

[imported_Yoshi]

All four power supplies mounted.

[imported_Yoshi]

Left side panel loose fitting.

[imported_Yoshi]

Right and top loose fit.

[imported_Yoshi]

A detail shot.

[imported_Yoshi]

Panels powered up with lights on.

[imported_Yoshi]

Hi-res pic.
Lights off panles powered up.

[imported_Yoshi]

More

[imported_Yoshi]

Detail of front panel etching

[imported_Yoshi]

Top/front lights

[imported_Yoshi]

Top lights.

[imported_Yoshi]

Lights on with panles powered up.